G B L

Very nice job. The vent size is an Rv industry standard, there are lots of Ac units fans and evaporate coolers that will plug into the flange you put on the roof.

Was there any water on the bottom of the lift gate? Have you used the rear wiper or washer Recently?

57600 miles the Rear Continentals were down to the Wear bars. The Continentals went about 42000. Replaced them with a set of Sumitomo Tire HTR A/S P02 Performance Radial Tire - 215/60R16 99V load index. The first impressions are very good. They were round and easy to Balance not needing much weight . The handling is comparable . The TC seems unaware of the 3% increase in the circumference. The Speedometer is 2 MPH low, no issue for me. The ride quality is noticeably better. While I was there the Rear pads were at 20% and the disc's were rusting (dirt roads and winter salt) . New Pads and rotors , (Rockauto $11.85 pads $14.56 ea. rotors )The brakes are now back to new. The front brakes are at 50 % so they will go further. Time will tell how good the tires are.

As long as it does not migrate into the Wiper Path you are good. When it does you will have to replace the windshield to get an inspection sticker

Sounds like both Conversion Companies could do a conversion top and inside unit for the TC. Looks like a nice job. 26000 + is a formidable price for a small camper.

Sounds great!! Hopefully North Korea will cooperate.

That's great Thanks for the follow up!!

If I were dropping the pan to change the filter I would make sure that it went back on with a drain plug. That would make the fluid flush a very easy job. If there is a problem with mixing the the fluid it will be noted on the speck sheet for the ATF. Valvoline's web site will have the PDF

Once you have Primed the panels there are lots of Automotive paints that have lots of effects. There are wrinkle paints Speckled paints , Flocking finishes lots. Keep us posted on what you do, don't forget the pictures

The wagon sliders Have Full plastic panels that complete the wagon interior. I am sure that they would fit .

Don what brand are your ramps? They must have the right ramp angle. The ramps in your picture have too much ramp angle.

If you go into ford parts the panels are available in Black Plastic for the wagon version. They are the same as the van and look great.

Let us know how you make out

Remove it carefully and use a small amount of pipe sealant on the thread if there is no gasket. looks like an easy fix

Looks like a great time!

Is everything the same on the new intercooler except the Thrust sensor port ? If it is then the Thrust sensor port could be added to it .

Your Tc has turned out very nicely.

Most of the Fluid that will not drain when the plug is pulled is in the Converter. If you Refill and run for 1 or 2 Min that oil is pushed out of the converter and back to the sump. If you do at least 3 drain and fills then you will get the old fluid out faster with less Mixing. The exchange will happen faster.

Sounds like a Dukes of Hazard movie !

I have changed the trans fluid twice at about 22000 miles(36000+ Km) and 53000 miles (88300 + Km) .The fluid was noticeably dark both times. I have several trailers I tow and live in hilly terrain. The fluid works hard and shows it . The cooler line is hard to Access so I use the multiple drain and fill method. There is a post I did with pictures if you want to check it out.

I thought about it but 15" rims will not clear the calipers and rotors on the Gen 2.

Nice post Tiller

I don't live in the western mountains where the turbo would help the altitude induced power loss, but in the mountains where I live the engine finds its up hill stride after 3000 rpms.

The synthetic that Don purchased is compatible with the Mercon LV.

4k won't shift it in S mode if you are standing on it 5600-6000 will do it.