Jump to content
Ford Transit Connect Forum
   

Leaderboard

Popular Content

Showing content with the highest reputation on 09/05/2019 in Posts

  1. A few of us here have installed a Sam's Club AGM battery which is much larger (both in size and in amp hours) than the little Ford spec OEM battery. There's a thread on it here which gives all the details - I don't recall offhand the battery dimensions, but I can personally guarantee you that you won't find anything which fills up the stock battery box better than the one we used - It's a very tight fit . . . . but it does fit with no modifications to anything Don
    1 point
  2. The aftermarket kits which give you steering wheel controls for the audio on your aftermarket radio *almost always* require you to give up the little screen and your back-up camera - They use the cable off that screen to tap into the CanBus signals. I have the Pioneer NEX-6100 nav radio installed, but kept the screen and my OEM back-up camera. Not sure Fords camera is compatible with your aftermarket radio, even if you knew which wires to tap into. It's a CanBus device too and I don't think aftermarket stereos are know what to do with those signals . . . . they're looking for a plain old video signal Anyway, good luck with your install and let us know if you find anything promising. The cheapest solution since you weren't looking for a nav stereo would have been to buy a used radio just like the one that came in your TC on eBay - Lots of those kicking around for $40 or $50 Don
    1 point
  3. Weird that they couldn't tell you. I used their website and it had options for use with 4.2 screen. This is what it looks like now. Still working out a couple kinks (will start a separate topic) but the radio and the rear camera work. I compared the options the website gave me for with and without steering controls and they appear near identical except that if you don't want steering wheel controls, you just leave off the 46 buck steering control module.
    1 point
  4. I'm going through a slightly different process now as my stock radio just died. My objective was to keep it as cheap as possible without buying another FORD Radio. I wanted to keep the 4.2 for my backup camera and I do all my nav with my phone anyway. I got the Metra kit for this configuration and I'm installing a DoubleDIN Sony radio. Haven't got the steering wheel controls working yet, but the Radio works and facia kit isn't amazing but looks good enough. All that said, my suspicion is that there is a way to splice the existing camera into the harness of almost any radio, if you can just identify the right wires.
    1 point
  5. Fifty150

    SHO Wheels on a '16 TC

    That is the only aftermarket wheel which I was able to find, which has the exact same dimensions as the OEM wheel. For whatever reason, even generic steel wheels do not have the same exact dimensions.
    1 point
  6. That would great, thanks. The PWFX mod is very cool, but before seeing that I was considering using some of these blocks I saw for a Jeep. Depending on the spacing between the bolt holes and the pin, I may need to drill/rout a notch in the side. Marinesurveyor, these may work for you too if it’s easier than getting square tubing cut/drilled.
    1 point
  7. Check the picture in the pdf. It might give you some ideas.
    1 point
  8. The Sam's Club Duracell Group 48 (H6) AGM battery is like the original, just slightly bigger, but still fits and can still use the original top bracket. The posts are exactly in the same place as the original. If I remember, pulling the air cleaner and bellows assembly will give access to removing the battery.
    1 point
  9. Don't get me wrong, I think AGM SLI batteries are fantastic, especially if you get a TPPL-type one. I've installed probably close to a hundred of them for my clients. Before LFP was an option (and it still isn't allowed by some sanctioning bodies), I installed the Odyssey PC680 into MANY cars because it was the lightest battery that would reliably start the car (and restart it on track if they spun and stalled it) in all weather. Do you know what the power draw (input Watts) is on the Segway charger? I'm curious to see how much you'll be sucking out of your SLI battery if you stop for lunch for an hour, 2 hours, etc. The rest of this is me looking up data and writing it down for future reference but it's relevant to this thread. The stock BXT-96R battery is a BCI Group 96R battery. The BCI 96R callout is 9.6" wide, 6.2" deep, and 6.9" tall. The terminals are auto standard, Right Hand Positive. Don says he fit a Group 48 battery in the stock battery box, which means it'll hold at least a 12.1"x6.9"x7.6" battery. Hawker has the Odyssey PC1200MJT, which is a TPPL AGM that blurs the line between SLI and DC. They claim it's a drop-in replacement for the Group 96R stock battery and has dimensions of 7.87"x6.66"x6.80. Compared the BCI 96R callout, it's slightly too deep but will have lots of clearance for height and width. According to Don's experience, it should fit just fine since his 6.9" deep battery fit.
    1 point
  10. I found it - Here's my earlier post Since I already had the battery out, and since it's already 3+ years old, and since it's so doggone difficult to get at . . . . and since I'm hooking up a high current load which will need to run off the battery when I stop for gas or to eat lunch, it only made sense to replace it with something better. Ford has chosen to use 'Ford sized' batteries in all their newer vehicles which I suspect was done to try and enhance battery sales at the dealerships. Our battery is a 'BXT-96R' which doesn't seem to exist anywhere but from Ford - Granted, you can buy a few 'equivalent' size replacements elsewhere Anyway, I wanted a higher capacity battery and I wanted an AGM, so after a good bit of research I settled on a Duracell Group 48 (H6) AGM from Sam's Club - $159.99. It has a 20 amp hour rate of 70 (3.5 amp draw for 20 hours) and much better specs than the OEM battery and it's made in the USA. 3 year free replacement and a 5 year pro-rated warranty Battery Electrolyte Composition: Glass Mat Battery End Type: Top Post BCI Group Size:48 CA at 32 degrees F:875 CCA at 0 degrees F:760 Polarity: Right Positive Reserve Capacity:120 The BXT-96R has only 500 cold cranking amps It's *almost* a drop in replacement for our OEM battery. It's about 1/2 inch taller, but fits in the battery box OK and you can even use the OEM hold down clamp if you remove the rear battery box spacer so the battery can slide back just a little to center the battery on the hold down studs. Then the clamp fits OK if you raise (or remove) the lifting handles that come on the battery - They fold back down after the clamp is installed, so you don't have to remove them If you intend to run high current accessories for even a short time with the engine not running, an upgrade to a better battery is probably a smart move . . . . especially if your current battery is 3 or 4 years old Hope this helps! Don
    1 point
  11. I did. I ran a #4 cable to the back of our 2014 and installed a 500 watt inverter to recharge our Segways as we drive. I wanted a stronger, deep cycle AGM battery under the hood so if we took an hour long lunch with the van shut off, the inverter wouldn't run the battery down - Sounds like exactly what you're wanting to do I don't recall the model number on the battery I used - That info may be listed here in a thread I did about the install . . . . . I'll look later when I have more time. I measured the old battery, measured the inside dimensions of the battery box and found an AGM at Sam's Club which was a little larger than the stock battery (with more amp hours too) and it looked like it would fit and it did. There's a spacer tin the battery box to keep the OEM battery from moving around and if you remove that, there's room for a larger (longer) battery - It can be a bit taller too, IIRC Don
    1 point
  12. Booner

    Better Battery

    You can configure your alternator to charge your car battery and house battery at the same time, I wrote a long post on how to do it somewhere on this forum about a year ago. Or go to "Battery1234" for instruction on how to do it. I've also purchased a POD (power on demand) to jump start my vehicle in case of a dead battery. I haven't had to use it on my car but I have on a car at the local Wal-Mart and it started right up. I wouldn't travel without it
    1 point
  13. thx138

    Better Battery

    Die Hard Platinum are made by Odyssey, great battery if they will fit. Say away from the Optima stuff, they are very low quality now.
    1 point
  14. mrtn

    Better Battery

    You can always go for diesel battery (80-100Ah).
    1 point
×
×
  • Create New...