Leaderboard

Hey there MRTN, that is a heat press. A George Knight 20S, weighs about 200 pounds. I do dye sublimation plaques, mugs and t-shirts at car shows. It is hard to see in the picture but the box that it sits on has a sliding lid that is supported by having a 1 1/4 ball mounted in the receiver and then a piece of heavy duty conduit that helps hold up a small 2 x 4 frame under the sliding shelf that I temporarily attach before pulling out the shelf. When the press is not in the van access to inside the box is accomplished by lifting the lid/shelf. As far as wrapping the van I am eventually going to use magnetic signage while at shows as that I have spoken to some other vendors who have said sometimes they wish they were not advertising full time for various reasons so with that in mind it is easy enough to slap a magnet on or off when needed, I just have not pulled the trigger on them yet as that I just started this in late July and as you can imagine there are no car shows now here in New England. GBL, I am by no means an expert but if you have a heat press question maybe I can help, believe me I lost a lot of product by learning on the fly.