Jump to content
  • Custom Search


LESD

2015 TC transmission fluid change

Recommended Posts

I need to change the transmission fluid on my 2015 TC. I see videos for the 2014 but they aren't the same. Can someone shed some light on this, I'm not taking it to a dealer.

Share this post


Link to post
Share on other sites

There's a drain plug on the bottom. The fill cap on top is next to the air filter box, and hidden from plain sight, beneath the radiator hose.  There's also a fill port on the side for measuring fill level.  You can use a container with volume level indicator to catch the drained fluid, mark the level, then refill with the same volume.  A paint store will sell plastic buckets in different sizes, which are marked for liters and quarts.

Share this post


Link to post
Share on other sites

Use Low Viscosity transmission fluid.  Different brands, including Ford MotorCraft, have LV fluid.

Share this post


Link to post
Share on other sites

I saw a plug on the side of the transmission on the drivers side but compared to a 2014 TC it's in a different spot, it's lower on the side of the transmission. I'll have to dig around and locate that fill cap. The drain plug was the easy part to find lol.

Edited by LESD

Share this post


Link to post
Share on other sites

Thanks for the pics. I'll take a look this morning.

Share this post


Link to post
Share on other sites

Here is the post I did on the Transmission Change.

The hardest part of this operation will be getting the TC Jacked up. Should be almost level . Remove the Under body dust shield . Look for the Drain Plug. 11 mm or 7/16 wrench.

Trans Drain Plug Small.jpg ] Trans fill vent General Location Small.jpg Trans Vent Cap 1Small.jpg

This style funnel will slide down into the Vent plug you just removed Put 3 quarts of fluid in

[attacjpg] ] Trans funnel small.jpg

Run the TC for 5 to 10 minutes . Then drain the fluid again. Repeat this 2 more times You have Now used 9 quarts of fluid.

Put the Drain plug back in make it snug this time. Add 3 quarts of fluid You have now used 12 quarts.

Go under the car and Look for the indicator plug (14 mm wrench) Loosen the plug. Do not remove yet

Trans Fluid Level indicator Plug Small.jpg

Start the engine with the engine running and the Car in park pull the plug and add fluid into the funnel until it just drips out the Indicator hole Replace plug put the Dust shield on , Pull the funnel and replace the vent cap. Total Fluid 13 Qts. With most of number 13 left

There is no filter to change on this operation and the type of fluid is Mercon LV. 

Have fun! 

I  have changed the fluid 3 times at 25000 Mile intervals and the fluid in this trans works hard.

Share this post


Link to post
Share on other sites
5 hours ago, G B L said:

 

The hardest part of this operation will be getting the TC Jacked up.

 

 

 

My solution is to use UniJacks.  Buy four of them.  Your car will be perfectly supported, with all 4 jack points at the same height.  With a maximum lift height of 21 inches, you should have plenty of room to crawl under, safely, and do everything that you want to do.  

https://www.etrailer.com/Tools/Powerbuilt/ALL620471.html

Image result for unijack

Powerbuilt Unijack Bottle Jack with Built-In Jack Stand - 21" Lift - 6,000 lbs

Item # ALL620471

Powerbuilt logo
lowest price pledge

Retail:$121.90

Our Price: $88.25

Orders above $99 qualify for FREE SHIPPING

5 hours ago, G B L said:

 

Go under the car and Look for the indicator plug (14 mm wrench) Loosen the plug. Do not remove yet

 

The only thing that I have to add to that would be, remove the breather cap and break the torque on the indicator plug first.  Make sure that you can add fluid back in, before you drain anything out.  You don't want to drain the fluid first, only to find out later that the fill port cap or indicator plug is stuck.  

Share this post


Link to post
Share on other sites

For many years, most of the guys I knew used paint mix buckets.  Drain into a pint mix bucket, so that you can actually see how much came out.  Use a piece of blue painters tape on the outside of the bucket to mark the level.  Pour the used fluid into your recycling container.  Fill the bucket up to the line you just marked.  Then funnel the fluid from the bucket.  You will have refilled with exactly what came out.  Assuming that you don't have any leaks, and that your fluid level is correct, you should be fine.  You're looking for 4.7 quarts.  So a 5 quart may be a little small.  Go up to 10 quarts.  

 

Related image

 

Image result for 10 quart paint mix bucket

Share this post


Link to post
Share on other sites
5 hours ago, G B L said:

 

This style funnel will slide down into the Vent plug you just removed

 

 

How does that cap remove?  Turn counter-clockwise?  Push down & turn?  Pull up and it should pop off?

Share this post


Link to post
Share on other sites

Twist and then pull, it is a friction fit.

And I have already showed you how I jack My TC up!image.png.c259289f189030cf732c20f50640ec0f.png

Edited by G B L

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×