Jump to content
Ford Transit Connect Forum
   

Leaderboard

Popular Content

Showing content with the highest reputation on 08/01/2016 in Posts

  1. On 2015 Transit Connect there is a current recall for instrument cluster problems. It is a software issue. Your fault is possibly related to the Power Control Module (PCM). Maybe time to see a dealer http://www.lemonauto.com/complaints/ford/ford_transit_connect.htm N NEWS: Ford is recalling certain 2014-2015 Ford Escape and Transit Connect vehicles; ELECTRICAL SYSTEM Report Receipt Date: JUN 24, 2015 NHTSA Campaign Number: 15V406000 Component(s): ELECTRICAL SYSTEM Potential Number of Units Affected: 182,520 JULY 2015 -- Ford Motor Company (Ford) is recalling certain model year 2014-2015 Ford Escape vehicles manufactured May 19, 2014, to February 6, 2015, and Transit Connect vehicles manufactured May 13, 2014, to December 10, 2014. Due to a software incompatibility issue, the instrument panel cluster be inoperative including a blank multiple functional display (MFD), and non-functional warning chimes, messages and warning lights. Specific warning chimes, messages and warning lights. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 101, "Control and Displays." If the instrument cluster is inoperative, the driver of may not be warned of safety related issues such as low tire pressures or disabled air bags, increasing the risk of personal injury or a crash. Ford will notify owners, and dealers will update the instrument panel software, free of charge. The recall is expected to begin August 10, 2015. Ford's number for this recall is 15C03. Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
    1 point
  2. On 2015 Transit Connect there is a current recall for instrument cluster problems. It is a software issue. Your fault is possibly related to the Power Control Module (PCM). Maybe time to see a dealer
    1 point
  3. rwalsh

    Micro Camper

    Had to take some time away, but now it is starting to come together little by little Increased the bed size by using a foldout section with a hinge, added "shore power", installed a desk/kitchen area
    1 point
  4. Yup, nice meeting you TOASTERvan! Thanks for the wheels!
    1 point
  5. slybert

    Micro Camper

    Thanks. The website does not tell much about installation http://www.fantasticvent.com/ I also was a bit scared about that hole but I went just fine. You will have to fill the ribs of the roof, they are about one half inch deep. I used small pieces of plywood for the outside. For the inside, I also used the same plywood but pieces were larger. I used masking tape to determine the position of the fan. You must use a metal blade of course. I punch-marked and pre-drilled small holes once I was sure everything was right. You need about 3-1/8" wide pieces X 16" long (2X) and 3" long (4X) for the center ribs. These pieces were stucked between the roof and the headliner. That will provide the screw some more material to grip correctly. The fillers are held in place with butyl tape. The fan base must have a nice strip of butyl to seat on, all around, and overlaping the last inch is a good idea. I filled the ribs and went around the fan with silicone. I finished with a strip of Sikaflex on the screw heads to make sure the water will not make its way through. The fan has 3 speeds and reverses too and only draws 3.0 amps for 920 cfm at max speed.
    1 point
×
×
  • Create New...