Jump to content
Ford Transit Connect Forum
   

Rick4

T.C. Member
  • Posts

    5
  • Joined

  • Last visited

About Rick4

Profile Information

  • Region
    European Union
  • My. T.C.'s Year
    None

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I just found issue, and solution. At engine rear center has bolt on EGR valve. That valve can be moving helping with a vacuum membrane, that membrane was worn out, so if screwed a small bolt into that vacuum line end, to seal vacuum line, and puch back line to EGR vacuum line connector. After that point my P2598 code goes avay forever, i driven my van cca 4-5000 miles, but never get any error code or any isse. I started it in really winter conditions, in -8°C, but runs fine after every starting, checked with code reader, don't find any error code.
  2. Hi All! I just planned to replace factory audio to a 2din bezel and a 9" android radio 4/64, maybe the best performance. I know, what the basic wiring color/function, but i want to use factory steering wheel buttons, and lamp dimming also, so ask all, who know, what cable will be the steering wheel wire and what will be the dimming wire. If i found that, i will be update post with photos. Thanks!
  3. I replaced turbo boost control sensor, but same behavior, nothing changed. The sensor shows to the ecu the actual position, so the vacuum solenoid, and actuator position sensor, ecm and wiring harness all good, if i start engine, and stay in place to idling 10 minutes, after temp gauge shows 70+ °C, but if i start car, and driving immediately, i get error code if i push RPM over 2000. In the hot summer i must re- start within 1 km driving, and it works good until i arrive at home. Next day same. I checked all, but i haven't a good scanner, the secret is an engine temp, over 70+ i can"t get error code. Under after i start car, i get. Thank you for that helping.
  4. Thanks, i cleaned all, checked all, can't found nothing, changed pressure valve, changed turbo vane actuator sensor, and then i get error code again. :-))
  5. Hi all! I have a '14 Transit Connect with an 1.6 TDCI engine, all ok, but 2 weeks ago began a small issue. If i start it morning, and drive only 500 meters, once revving over 2000 rpm, i get fault code P2598, van stuck in limp mode, i lost 30% of power. I know, firstly will be a turbo actuator, or vacuum ball issue, cracked vacuum hose, or anything under hood, but not, if i simply switch car off, restart it, and then all problems gone, works good without any issue until evening. So i think, there is no turbo actuator problem, no vacuum hose problem, all ok, if i restart the car. In this case it's not will be a temp- related issue, after 500 meters all cold in the engine bay. What can i do in this case? I can't found noting. Thanks for helping.
×
×
  • Create New...