I have just replaced the O/S unit on my 65 plate Connect 240 LTD, following a hefty pheasant strike yesterday !!! £182.44 replacement unit from Hendy...
Above posts refer to different model I think, but there are no 'bottom bolts' on this model...no need to remove any bumpers, trims or anything...
Switch off lights & ignition...remove connector block from unit.
Undo the top back screw, including odd shaped fixing plate, near bonnet hinge, then remove a couple of securing clips under the rubber trim along front above front grill.
This will allow a bit of 'wiggle room'
Remove the bottom screw...then look at your new unit...note what sticks out where etc, this will help greatly with removal of old unit.
Just a case of carefully lifting, turning, easing etc till its out.
Wiggle and turn, ease new one in, replace screws, weird looking plate, and clips etc.
Check everything works OK
Don't forget to save any working bulbs before you chuck the old unit.
...Final note...
The £182.44 handed over to Hendys...the unit is complete, including all bulbs, only things to re-use are your 2 fixing screws.
Hope that helps someone out, I arrived here following a Google search...but nowt came up specific to the newer model.
(Admin /mod please edit / move to more relevant section if required)
