trekex8

Hi, wondering if anyone can help, i have just purchased a wheelchair adapted connect. I would like to fit a towbar to the connect to enable me to tow our trailer & fit bike rack. A large chunk of floor is removed as well as the rear bumper. To fit a towbar normally, the bumper comes off then the box section is removed. The towbar is a reinforced box section which replaces the original, there are also a couple of extra outriggers for support. The ball is on a plate attached to the box section. Thanks in advance George

Thanks ecore8, The second link was spot on, Not sure if you know this, on the second link it shows a floor extention piece fitted. is this normal practice during manufacture. So this piece could be removed from a van to give access to a foot well, for rear seats. Sorry for all the questions, i havent got a van yet only at the reserch stage. I dont think that the configuration i want can be bought as standard, so i will need to customise rear of van. G

hi folks looking to convert a transit connect possibly a tourneo, could someone tell me how long the bed is from the back door to the front of the rear seats. thinking about fitting two single rear seats with bike back wheel fitting between them (front weel removed). Thanks....

Hi from a wet Scotland, I am thinking about getting a connect lwb to carry my Mountains bike about when out cycling. got a few ideas on how to convert inside to suit my needs but this is not the place.